FIRST POST HERE!!! Hi all! I have a doubt...

eMVy · Post by **eMVy** » Mon Nov 03, 2003 12:24 am

Well, first IÂ´d like to say HI to everyone that posts here. ItÂ´s a great forum and provided me help when I needed.

Now, I live in Brazil and here itÂ´s hard as hell to get specific 206cc tuning parts, such as the clear backlights.

Now, itÂ´s easy to find the 206 hatch clear backlights, IÂ´d wanna know if itÂ´s possible to "adapt" those lights to a 206cc. And if so, how could it be done and would it affect something?

Thanks in advance. Loved the boards.

Derek · Post by **Derek** » Mon Nov 03, 2003 12:40 am

i have rear lexus lights intended for a standard 206. they can be cut to fit the CC.

all you need to do is get the clear lights and remove your existing light and put them side by side to see where to cut.

just ensure you take your time and use a sharp knife. if in doubt don't cut away the full bit of plastic in one go, just a bit at a time

eMVy · Post by **eMVy** » Mon Nov 03, 2003 12:43 am

but the cuts are in the internal part ou will it be visually noticeable?

So to do this, someone who works with car tuning can easily do it, then?

eMVy · Post by **eMVy** » Mon Nov 03, 2003 1:01 am

Is this it?

Huu · Post by **Huu** » Mon Nov 03, 2003 7:23 am

hi,

no , it doesnt cut to internal parts just a pieces of plastic flaps ouside the light everything else should connect in as usual (no wiring mods), dont need a person who work in carparts to do it you can do it with ease just as derik said take time you'll be fine. (yeah just like the picture, but in my case i found it better to leave about 5mm further then the black line shown on the picture to give it a nice tight fit)

Post by **Lyndon** » Mon Nov 03, 2003 6:49 pm

Is this it?

yes that's correct, that's all you need to cut away