changing 206cc interior

[stokes]

hi everyone, just brought a full leather interior including the door cards for my wifes 206cc, does anybody have a step by step guide on how to do it, cheers matt

[yorkielassy]

There is a "how to" on the 206info with pics. It's a hatchback but not too different from the cc. I changed mine a few months back and didn't take very long. It might be idea to buy some interior clips as these can break off when changing the door cards. Also check your connectors under the front seats and make sure they match with your new interior or you may have air bag lights on.

[yorkielassy]

Also have a look on the link
http://www.peugeot206cc.co.uk/repair-206/

[Capncol]

Firstly make sure the plugs under the seats are the same, and that it has the same airbag set up on the seats otherwise you will get an airbag light on the dash (mot failure)

Start by putting roof down. Makes it a lot easier.
Rear seats
Undo the 2 bolts, 1 under each seat squab. Pull up front edge & pull forward to remove.
Under the seat back is 1 bolt each side (you may have to bend bottom edge up slightly to see them) Remove these and the seat back slides up and out.

Front seats
Undo the plugs under each seat, slide seats right back and undo the 2 front torx hd bolts on each seat. Slide forward and remove the 2 torx hds at the rear of each seat. Remove seat.

Door cards
Wind window down.
Take off interior trim for mirror, it un clips but be careful. They are brittle.
Lever out the interior door handle trim with a screwdriver. Use masking tape so you don't damage it.
Take out the self tapping screws in the leading and trailing edge of the door card and also in the "pocket" type handle.
Starting at the bottom and working towards the top un clip the retaining clips carefully with a broad screw driver levering on the clip & not the panel. Again be careful, they break easily. Once all the clips are released, while pulling the bottom edge of panel away from door, lift the panel upwards in side to side - see saw motion to release the top edge from the window guide. Remove electrical connectors and remove panel

[stokes]

thanks for that, the plugs under the seats are the same.

[stokes]

Just changed the front passenger seat the air bag connecter was the same plugged it in started car up now I've got air bag light up on dash board, any suggestions I would be very great full

[Capncol]

Are you sure the plugs were the same?
Did you count the pins?

[stokes]

Plugs look exactly the same I didn't count the pins, I have read online you can cut the connectors of and join the wires but I don't really wanna do that, it's looking like putting the cloth sit back in and sell leather interior on

[stokes]

The leather interior seems 2 be wired different 2 my original seats

[Capncol]

The leather interior seems 2 be wired different 2 my original seats

Yep. Not surprised.

[stokes]

Is there still a way to get a leather interior to fit my car with no air bag light problems