Hi all, I to have economy mode problems and have followed the procedures on this site to no avail. The engine turns over but won't start and now it also tells me an anti pollution problem. Any ideas anybody???

Col thanks for the info on removing the steering wheel airbag. I followed your instructions and it worked out great. Unfortunately reassemble was good except didn't have the wheels straight enough and steering alignment out slightly although not enough to worry about.

Thanks IanL the previous owners of my pug have bastardised the radio and have cut all the wires to remove the oem radio and have put an aftermarket radio that doesn't even fit the dash properly and looks ugly. I will go ahead and get the radio fitted thanks to your advice.

Thanks gazza82 i did think of fitting a small roo bar but the licensing rule prohibit it because there has been no research into roo bars fitted to peugeot 206cc. bloody bureaucrasy.

Hi all hope this is not a silly question but I have access to a radio unit from a 2007 206 hatch and am interested in putting same into my 206cc. From what I read from the owners (hatch) manual they cannot be put into another vehicle. This doesn't make sense to me so I am asking the forum for an opi...

Hi all here I am again looking for help. I have a 2003 206cc that is prone to running into kangaroos (3) and to help with panel parts have bought a 2007 206 hatch with broken engine. The left rear window does not operate and is just hanging partly open. My question is can I use the electric window p...

Woo Hoo just finished changing timing belt and water pump on my 1.6 and thanks to KJ16V step by step guide I managed to complete it myself. Although saying that I had a couple of problems the major one being the water pump would not dislodge from engine resulting in having to get assistance from a m...

Hi all can someone confirm the coolant capacity of the 1.6 engine. I have been told it is 7 litres and another told me 6.2 litres.

Hi Ron I to am having problem with cooling system and I have tried to access http://www.peugeot206cc.co.uk/viewtopic.php?id=10868 but it is not available anymore. Any chance you could post it again???
Regards
Fiona

Thanks everyone. I had to send my pp2000 back although I religiously followed the installation instructions listed here I could not authorize the installation and was getting very little help from the supplier. It was cheap but how cheap is cheap when it doesn't work. After all that off to auto elec...

Hi all I have just noticed that when I switch the headlights to high beam the low beam lights go out as does the green light warning on dash and is replaced by the blue high beam warning light. I have not had the car on the road long and find the lighting to be poor. My car is a march 2002 206cc 1.6...

Hi all and thanks to SLO it must be the charcoal filter because on closer examination I could see fine particle of black filter stuff. Now is this going to cause problems if I use the car untill I can replace it???

My car is a 2002 206cc 1.6 auto and has been involved in an altercation with a kangaroo. Now my problem. There is a black plastic cylinder thing fitted to the body inside the front right fender. It has two plastic tubes attached to one end nearest to windscreen/door and an extrusion out of the other...

Ianl I am persuing that train of thought and have lodged inquiries with the appropriate manufacturers.

Hi all, my poor car looks terrible but at least I have straightened out the damage caused by the roo although I am not a panel beater by any stretch of the imagination. At least the panel fits now but is too lumpy to remain so have ordered a new one. The headlight is another story. I hope to have a ...